Home » Applications » Plywood for furniture

Plywood for furniture

We have 10 mass production lines for furniture grade plywood , the monthly production sums up to 5,000-10,000 cubic kilometers, therefore we make sure to hand in products in time. Our factories are all placed near the raw material areas, where we can buy raw materials at a reduced price. Because of our bulk buying, the manufacturers of raw materials are also glad to cooperate with us in the long term. Our factories are also near the dock, meaning the cost for transporting is also reduced. These conditions make our products more cost competitive in the market. What's more, we also have a professional quality control team, which control the quality from the source—raw materials. Every procedure of production is inspected by our professional staff, and we make sure the quality reaches our clients' demand.

Based on your needs we have following products for you to choose from:






We have considered a series of problems that may occur while usage:

    1. DelaminationDelamination
    2. This means there is a glue problem. The glue we use on all the products are self-developed, so that the quality can be guaranteed. Meanwhile, we strictly control the pressure to make sure the glue amount not under the standard value. Every production line has dryer to reduce the moisture of veneers before spreading glue.
    1. Voids or peelingVoids or peeling
    2. Voids or peeling may be caused by thin face veneer. We choose face veneer with the standard thickness.
    1. MouldMould
    2. Mould is caused by too much moisture. Every production line is equipped with dryer to make sure the veneers at a good humidity level. Before packing the moisture is to be tested
    1. Short of coreShort of core
    2. We don't use materials of inferior quality, nor crushed materials; we will also control the core processing procedure.
    1. DelaminationLoose on the edge
    2. Loose on the edge is caused by lower density. For OSB we control the density between 600-650kg/m3. The amount of glue and press pressure is not under the standard value.
    1. Waste on the panelWaste on the panel
    2. After the wood is sliced we have to filter the wood chips to remove the impurities. Our production facilities are also cleaned at regular intervals to make sure no waste is left.
    1. DelaminationOil stain on the panel
    2. The production facilities are cleaned at regular intervals to make sure no oil stain is left.